Domain Controllers are on the same network. NTP is properly configured and time sync is active and current. Domain Controller IP addresses and port requirements. Domain Controllers configured to Microsoft Best Practices. All platform files and templates available in a file share accessible to the service provider and tenant. Datastores provisioned and allocated for service providers and tenants. All required network visibility, routing, hardening, and so on, configured ahead of time. One network type used across all appliances (Standard Switch VLAN, vDS VLAN, or VXLAN). Because you need approximately 400 IPs across 200 appliances (primary/standby), consider using a /23 mask instead. IP ranges planned to accommodate your maximum appliance estimate.įor example, if you plan on accommodating 200 total appliances, a /24 mask gives you a maximum of 254 usable IP addresses. BBLL (Backbone Link Local) network created and IPs designated to SP appliances. 
Front end/management network created and IPs designated to SP appliances.Individual ESX Host mapping is not supported.
You are prompted to do this at the end of each set of installation and upgrade steps. Note: To use a single vCenter Server configuration, you must set the
0 kommentar(er)
